Runco VX-2000d - Manual (Page 72)

Operation
60 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
most accurate colors. If it does not, try the other choices and select the one that does.
HDMI Black Level: This control compensates for incoming elevated black levels present
in certain video signals. When you set it to Auto, the VX-2000d automatically determines
the best setting according to the incoming video signal type. For some types of video, you
may want to override the setting. Set it to 0 IRE if blacks appear elevated (dark gray). If
blacks appear “crushed” (too dark), set it to 7 IRE.
Background: Select Background from the Options menu, then press or to select
the image background – solid blue, solid black or the Runco logo welcome screen. The
Background appears when no incoming signal is present.
Power Save: Select Power Save from the Options menu to access the power
management features of the VX-2000d.
• RS-232C Port: When this option is set to On, the RS-232 port is always active and
consuming power, even when the projector is in standby mode. When set to Off, the
RS-232 port is inactive and does not consume power when the projector is in standby
mode.
• Auto Power Off: When this option is set to On, the projector enters standby mode
after 15 minutes of inactivity (no input signal). Five minutes before this is to occur, the
message “Enter STANDBY mode in 5 min.” appears on-screen. This message updates
to indicate the amount of time before the projector enters standby mode.
When set to Off, the projector remains in the “power on” state regardless of the
presence or absence of an input signal.
Baud Rate: Select Baud Rate from the Options menu, then press the or button to
select the projector’s RS-232 baud rate. This function is used to change the transfer rate
of the RS-232 connection between the projector and the DHD Controller. The default
setting is 9600 bps. Do not change it unless specifically instructed to do so by
Runco Technical Support.
Fan Mode: If the projector is being used in a high-altitude environment, use the Fan
Mode control to prevent it from overheating. Set it to High Altitude (2) to run the fan at high
speed; set it to Normal (1) to run the fan at normal speed.
Orientation: Refer to Adjusting the Picture Orientation on page 32.
Factory Default: To reset all projector settings (including image settings) back to their
factory defaults, choose Factory Default from the Options menu. When the confirmation
message appears, select All Reset to perform the reset or Return to cancel. This action
is not undoable. Proceed with caution!
Always set this option to On. Doing otherwise may disrupt
communication between the projector and DHD Controller.
When you set the Auto Power Off function to Off, the LED function
(refer to page 59) is automatically set to On.
The Factory Default command does not reset the Lamp Timer or
OSD Language setting.
Caution
Note
Note