Runco VX-2000d - Manual (Page 62)

Operation
50 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the VX-2000d will respond. By default, both are set to 17. You
can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the VX-2000d/DHD remote control (Figure 2-5) in ways that are unpredictable or
undesirable.
• You have multiple VX-2000d projectors and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
projector.
When you change a remote code on the VX-2000d, you must re-program the
VX-2000d/DHD remote control to send that same code. To do this:
1. Using a straightened paper clip or similar object, press and hold the
CODE button on the remote control for approximately three
seconds, or until the red LED on the remote lights solid red.
2. Enter a new two-digit code between 00 and 31 inclusive. Include a
leading zero for single-digit codes; for example, enter 9 as “09.”
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Display Device: The options in the Display Device menu allow you to change the picture
orientation, adjust the amount of overscan and access other projector-specific functions.
• Configure: Select Configure from the Display Device menu. Then:
• Orientation: Select Orientation to change the picture orientation to suit the method
of installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear).
• Overscan: Refer to Overscan on page 46.
• Lamp Power: Select Lamp Power from the Display Device menu to adjust the lamp
output level. You can choose to run the lamp as bright as possible (“1”) or you can
choose the lower setting (“0”). Generally, lower lamp output can prolong the life of
the lamp, but decreases brightness.
• Fan Mode: If the projector is being used in a high-altitude environment, use the Fan
Mode control to prevent it from overheating. Set it to High Altitude (“1”) to run the fan
at high speed; set it to Normal (“0”) to run the fan at normal speed.
• Lamp Hours: To display the number of hours that the lamp has been in service,
press or to highlight Lamp Hours.
Use the DHD Controller front-panel keypad to change the projector
IR code. Then, change the code sent by the remote to match as
described below.
Do not change the “Type” setting in this menu.
Tip
Note