RuggedCom RSG2300 - Manual (Page 28)

4. Technical Specifications
RuggedCom® RuggedSwitch® 28 RSG2300 Installation Guide Rev 110
4.4. Copper Ethernet Port Specifications
The RSG2300 features a fixed set of three fixed banks of eight 10/100Tx copper ports each, and
can be ordered with additional 10/100Tx ports in slots 1 and 2, and 10/100/1000Tx ports in slots
3 and 4. All copper ports have the following specifications:
Parameter Specification Notes
Speed 10/100/1000 Mbps
Auto-negotiating; 1000Mbps modules
supported in slots 3 & 4 only
Duplex FDX / HDX Auto-negotiating
Cable-Type > Category 5 Shielded/Unshielded
Wiring Standard TIA/EIA T568A/B Auto-Crossover, Auto-Polarity
Max Distance 100 m
Connector RJ45
Isolation 1.5kV RMS 1-minute
PoE Voltage 44-57V PoE ports only
PoE Current 350mA PoE ports only
Table 4.5. Copper Ethernet Port Specifications
4.5. Fiber Ethernet Port Specifications
The sections: Section 4.5.1, “10FL Ethernet Optical Specifications” through Section 4.5.3, “Gigabit
Ethernet (1Gbps) Optical Specifications” list specifications of the optical transceivers used in the
dual-port modules available for the RSG2300. The specifications are organized by signaling speed
and then by order code. Module order codes are contained within each product when assembled
and configured at the factory. Consult the RuggedCom ROS® User Guide for help in obtaining
the factory configuration data.
4.5.1. 10FL Ethernet Optical Specifications
Order
Code
Mode
Connector
Type
Cable
Type
(µm)
Tx
λ
(typ.)
(nm)
Tx min
(dBm)
Tx max
(dBm)
Rx
Sensitivity
(dBm)
Rx
Saturation
(dBm)
Distance
(typ.)
(km)
Power
Budget
(dB)
62.5/125 -16 -9 18
FL01 MM ST
50/125
820
-19.8 -12.8
-34 -11.2 2
14.2
Table 4.6. 10FL Ethernet Optical Specifications