Renesas Emulator Debugger M16C PC4701 - Manual (Page 120)

7.7.2 Specify the Combinatorial Condition
To specify a combinatorial condition, specify the desired condition from the combinatorial condition
specification area.
•
When AND or OR is selected
In the event specification area, the event used and a pass count for that event can be specified. To
alter the pass count, while the event to alter is being selected, click the pass count value of that event.
•
When AND (Same Time) is selected
In the event specification area, the event used can be specified. No pass counts can be specified.
•
When State Transition is selected
Click the Details... button, and the dialog box shown below appears. Specification by a state
transition diagram or sequential specification can be used. If the content of any event is altered,
it is marked with an asterisk (*) on the title bar. Once conditions are set in the emulator,
asterisks are not displayed. A time-out time in each state can also be specified.
106