Renesas Emulator Debugger M16C PC4701 - Manual (Page 167)

7 Windows/Dialogs
7.9.5 Specify the Trace Write Condition
Conditions for cycles to be written to trace memory can be specified.
Total Writes all cycles.
Pick up Writes only the cycles where specified condition holds true.
Exclude Writes only the cycles where specified condition does not hold true.
Also, following three write modes are supported.
Only cycles where specified event is established
Cycles from where specified event is established
to where specified event is not established
Cycles from where start event is established to
where end event is established
7.9.6 Command Button
The buttons on this window has the following meanings.
Button Function
Reset
Discards the contents being displayed in the
window and loads contents from the simulator in
which they were set.
Save... Saves the contents set in the window to a file.
Load... Loads event information from a file in which it
was saved.
Set Sends the contents set in the window to the
simulator.
Close Closes the window.
153