Runco VIDEO XTREME VX-33I - Manual (Page 30)

14 Runco VX-33i Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the VX-33i installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2 If installing a VX-33i/CineWide or VX-33i/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor 22
3 Mount the projector 27
4 Connect signal sources to the projector 28
5 Connect external controller to RS-232 port (optional) 33
6 Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional) 34
7 Connect projector and lens motor (if present) to AC power
and power up 35
8 For rear-screen and/or ceiling-mount installations, select
the proper picture orientation 36
9 Primary lens adjustments: projected image size (zoom),
position (shift) and focus 17, 37
10 Install CineWide anamorphic lens (optional) 38
11 CineWide lens adjustments: position, pitch (angle),
geometry and focus 40
12 Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position 47
Note