Runco VIDEO XTREME VX-33I - Manual (Page 81)

Runco VX-33i Installation/Operation Manual 65
PRE
L
IMINAR
Y
Image Preset Commands
SISF 0 Loads “ISF Night” image preset ISF Night
SISF 1 Loads “ISF Day” image preset ISF Day
SISF 2 Loads “Custom 1” image preset Custom 1
SISF 3 Loads “THX” image preset THX
Menu Navigation Commands
The following serial commands are meant to emulate buttons on the remote control or DHD
Controller front panel. Each button has its own serial command, so effectively it is as if you were
using the IR remote only you’ll be doing so via serial commands. These commands provide active
OSD responses just like the IR remote.
ENTR ENTER (or SELECT) button
(none)
EXIT EXIT button
MENU MENU button
MND Down-Arrow ( ) button
MNL Left-Arrow ( ) button
MNR Right-Arrow ( ) button
MNU Up-Arrow ( ) button
Picture Adjust Commands
The following serial commands are meant to emulate the discrete picture adjustment buttons on
the remote control unit. Use them in conjunction with
MNL and/or MNR to make picture
adjustments. For example, to increase Brightness by five increments, send this sequence of
commands:
MBR <Enter>
MNR <Enter>
MNR <Enter>
MNR <Enter>
MNR <Enter>
MNR <Enter>
EXIT <Enter>
MBR Adjust Brightness
(none)
MCOL Adjust Color Level
MCON Adjust Contrast
MTIN Adjust Tint
Table 6-1. Serial Commands and Responses (continued)
Command Description Response