Runco VIDEO XTREME VX-33I - Manual (Page 54)

38 Runco VX-33i Installation/Operation Manual
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)
The VX-33i Anamorphic lens mount kit consists of everything shown in Figure 3-18. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23RUNCO.
Figure 3-18. VX-33i Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
➤
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw and Washer
(2x)
T-Screw and
Washer (2x)
Pitch Adjustment
Anamorphic Lens
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Yaw/X Adjustment
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
10 Anamorphic Lens
Set Screw