Runco VIDEO XTREME VX-33I - Manual (Page 52)

36 Runco VX-33i Installation/Operation Manual
PRE
L
IMINAR
Y
3.8
Turning on the Power 1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see Figure 3-16).
3. Press the ON button on the remote control – or the SOFT PWR button on the
projector rear panel – to turn on the system. The vacuum fluorescent display on the
projector rear panel briefly displays “Starting Display.”
4. When the projector is ready for use (after about 20 seconds), the RUN LED on the
projector rear panel lights solid blue. The fluorescent display indicates the current
input source, aspect ratio and input resolution; for example:
3.9
Adjusting the Picture
Orientation By default, the VX-33i is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
inverted, you must change the picture orientation. To do this:
1. Press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Installation from the Display Device menu.
5. Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.
VX33i Component RCA
16:9 480I
Current Input Source
Aspect Ratio Input Resolution
You must enter a passcode to access the Service menu.
Note