Runco LIGHTSTYLE LS-10D - Manual (Page 53)

Installation
Runco LS-10d Installation/Operation Manual 37
PRE
L
IMINAR
Y
Connecting 12-volt
Trigger Outputs to
External Equipment DHD Controller: Connect retractable screens, screen masks or other 12-volt
trigger-activated equipment to the 12-volt trigger outputs on the DHD Controller; see
Figure 3-14.
Figure 3-14. 12-volt Trigger Output Connection from DHD Controller
Projector: If your LS-10d is equipped with an anamorphic lens, connect the lens
transport to the TRIGGER 1 output on the LS-10d; see Figure 3-15.
The DHD Controller automatically activates this trigger whenever the Cinema or Virtual
Cinema aspect ration is chosen.
Figure 3-15. 12-volt Trigger Output Connection from Projector to Lens Transport
You can also use a 12-volt trigger output on the DHD Controller to
control the lens transport; however, you must manually configure it
for this purpose. Refer to Configure Lens Motor Trigger on
DHD Controller (Optional) on page 43 for more information.
USB
To Accesso
Video 1 Y Video 2
Video 3 Pr Pb
HDMI 1 HDMI 3
HDMI 2 HDMI 4
Component / SCART
TRIGGERS RS-232
1 2 3
HD1
HD2
Tip = +12V
Sleeve = Ground
Retractable Screen or other
12-volt trigger-activated
device
3.5-mm
mini plug
+12V Trigger Input
Note