Runco LIGHTSTYLE LS-10D - Manual (Page 77)

Operation
Runco LS-10d Installation/Operation Manual 61
PRE
L
IMINAR
Y
Table 4-3 lists the Color Gamut settings and associated x- and y-coordinates for each
primary and secondary color component.
• PCE: To use the Personal Color Equalizer to define a custom color gamut, choose the
“PCE” Color Gamut setting (refer to Color Gamut on page 60). Then, choose PCE
from the Display Color menu and press ENTER.
• Hue/Saturation/Level: PCE provides the ability to define a custom color gamut in
terms of primary (red, green and blue) and secondary (yellow, cyan and magenta)
color hues, saturation and level (brightness).
Each control operates only on the color specified. Surrounding colors are linearly
interpolated based on their distance from each of these colors. In the CIE 1931 Yxy
coordinate system (see Figure 4-8), Hue rotates the color coordinates around the
white point, Saturation adjusts the coordinate's distance from white and Level
adjusts the luminance (Y) of the color relative to white.
Table 4-3. x/y Color Gamut Values
Primary
Color
Color Gamut Settings and Associated x/y Values
REC709 SMPTE “C” EBU
x y x y x y
Red 0.640 0.330 0.635 0.340 0.640 0.330
Yellow 0.419 0.505 0.421 0.506 0.418 0.502
Green 0.300 0.600 0.305 0.595 0.290 0.600
Cyan 0.225 0.329 0.228 0.326 0.220 0.329
Blue 0.150 0.060 0.155 0.070 0.150 0.060
Magenta 0.321 0.154 0.318 0.162 0.328 0.158
The DHD Controller uses the PCE settings for all display modes on
a given input.
Note