Runco LIGHTSTYLE LS-10D - Manual (Page 65)

Operation
Runco LS-10d Installation/Operation Manual 49
PRE
L
IMINAR
Y
Cinema CINEMA Select Cinema to view 2.35
source material in its native
aspect ratio.
With a 16:9 screen and a
standard LS-10d (without an
anamorphic lens), the upper and
lower portions of the screen are
masked, but the geometry of the
active image area is unchanged.
With a 2.35:1 screen and an
anamorphic lens, the DHD
Controller scales the 2.35:1
image so that the active image
area fills the 16:9 chip surface,
eliminating the black bars. The
secondary, anamorphic lens
then restores the proper
geometry to the 2.35:1 image.
Virtual Cinema V-CINE A 16:9 image is scaled
NON-linearly (more on the sides
than in the center) to fit a 2.35:1
screen.
Native NATIVE Select Native to display the
source signal in its native
resolution, centered in the
display area with no re-sizing or
overscan.
This means, for example, that
720p HDTV programs will
display with unused pixels on all
sides: 320 on the left and right
sides and 180 above and below.
With SDTV and EDTV sources,
the DHD Controller scales the
image horizontally to achieve a
16:9 aspect ratio.
Table 4-1. Aspect Ratio Settings (continued)
Aspect Ratio
Remote
Control
Key
Description
2.35:1 Image on
16:9 Screen
(Cinema aspect ratio / no CineWide)
2.35:1 Image on
2.35:1 Screen
(Cinema aspect ratio / CineWide)
16:9 Image on
2.35:1 Screen with
Virtual Cinema
16:9 Image on
2.35:1 Screen
16:9 Image on
2.35:1 Screen
1080i HDTV Image
720p HDTV Image