Olympus C-2040ZOOM - Manual (Page 186)

186
8
Mode setup
If you use or to select
"YES" and press the [OK]
button, the displayed image
is erased and the next image
appears. To cancel erasing,
press the
(Erase) button
or select "NO" and press the
[OK] button. The CHECK
confirmation screen then
reappears.
● If you switch the camera off
while an image is still dis-
played on the CHECK screen
image, the image is automati-
cally saved.
6
Saving/erasing images right after shooting (CHECK)
PO
W
E
R
/ M
O
D
E
D
IA
L
P
A/S
/M
OF
F
6 6
6
•
In Movie record mode or when you are using Auto Bracket to take shots,
you cannot take further pictures until you decide whether to save or erase
the current picture.
•
If you select the CHECK option when TIFF quality mode is set, the quality
mode changes. Do not use the CHECK setting in TIFF mode. (Switch to a
high-quality mode with the same resolution.)
•
You can still take pictures while you are using the CHECK option to check shots.
If you press the shutter button down halfway, the display on the monitor
changes and an image appears with focus lock applied. The CHECK confirma-
tion screen reappears 5 seconds after you switch to the photography screen.
•
While you are using the CHECK option to check shots, you can switch
between the "P" and "A/S/M" modes. If you switch between these ("P",
"A/S/M") modes and "
", all the pictures currently stored in the buffer mem-
ory are automatically saved.
•
If you take a picture while you are using the CHECK option, you cannot
select the following settings in the photography menu: "DRIVE", "
",
"CARD SETUP", and "MODE SETUP".
•
Never remove the card or replace the batteries while you are using the
CHECK option as the data in the buffer memory will be lost.
•
The menu screens cannot be displayed while you are using the CHECK
option. Exit the CHECK screen before using the menus.
•
The selected setting is retained until changed, even when the camera is
switched off.