Onkyo MD-105TX - Manual (Page 12)

12
Connecting to the other components (continued)
Connecting the ( ) controller
If you are using other ONKYO components
equipped with
connectors, you can control
these components using the amplifier's remote
controller.
Before connecting
• The amplifier must be connected to the
system hookups for control operation.
• Each component has two connectors.
There is no difference between these
connectors.
• The components may be connected in any
order.
• Remote control operation is not possible if
only the remote control cable is
connected to the connectors. Connect
the audio connection cables correctly.
The illustration below is an hookup
example. With these hookups, you can operate
the CD Synchro Recording (see “CD/MD synchro
recording” on page 9).
Note
An
remote control cable equipped with a
1/8 in. (3.5mm) diameter miniature two-conductor
phone plug is included with this unit and with
every tuner and cassette deck that bears the
mark.
Connecting the AC power cord
(mains lead)
Insert the AC power cord into a wall
outlet. The STANDBY indicator lights.
Tuner
MD-105TX
CD player
Amplifier
cable
• To use the unit with the other Onkyo Separate
Collection series components, follow the
connection diagram in the A-905TX/R-805TX
instruction manual to connect the unit to the
system.
• If you press the EJECT button while the unit is
in STANDBY mode, the power will turn on and
the display will light up automatically.
STANDBY
STANDBY/ON