Onkyo MD-105TX - Manual (Page 27)

27
Befor
e Using
Connections
Other Information
Operations
3
Press the INPUT button
repeatedly until “Digital In 1” or
“Digital In 2” appears.
Digital input source 1 or 2 is now selected.
or
Note
• Make sure the supplied optical cable is
connected to the correct digital input
terminal. If you attempt to perform digital
recording using a digital input terminal
that is not connected, “D.In Unlock” will
appear.
• Use the DIGITAL INPUT 1 digital input
terminal if you connect the C-705TX CD
player to this MD recorder.
4
Select a recording mode.
Refer to Step 4 on page 22.
5
Play the recording source.
If the C-705TX CD player is connected to
the system, start playing the CD player.
Recording (continued)
Digital recording
In digital recording, an optical digital cable is
used to input signals from the recording source.
About digital recording
The MD-105TX is equipped with a sampling
frequency converter, which enables you to
record digital signals (PCM 32kHz and 48kHz)
transmitted from external digital devices (DAT,
satelite broadcast, etc.), as well as CDs (PCM
44.1kHz).
1
Press the STANDBY/ON button.
The STANDBY indicator goes out.
2
Load a recordable MD.
Refer to Step 2 on page 24.
MINIDISC RECORDER
STANDBY
CD
INPUT
DUBBING
PUSH TO ENTER ( )
AMCS
DISPLAY EDIT / NO YES
REC
STANDBY / ON
MD- 105 TX
REC MODE
INPUT REC MODE
STANDBY/ON
INPUT
DIGITAL IN 1
DIGITAL IN 2
STANDBY
STANDBY/ON
(Continued on the next page)