Omega 1002 - Manual (Page 45)

6. Diagnostic Program
6.1 Power-ON Plug & Play Test
Below are the steps for the power-on Plug & Play test:
Step 1: Power-off the PC
Step 2: Install OME-PCI-1002 without any extra external connections
Step 3: Power-on the PC and watch the PC screen very carefully
Step 4: The PC will perform its self-test first
Step 5: The PC will detect the non-PCI physical devices installed in the system
Step 6: The PC will display the information for these devices
Step 7: The PC will detect the PCI Plug & Play devices installed in the system
All PCI-device information will be shown Æ pay careful attention
Æ There will be a PCI device with vendor_ID=1234, device_ID=1002 (OME-PCI-
1002)
If the Plug & Play ROM-BIOS successfully detects the OME-PCI-1002 card during
the power-on state, the DOS and Windows software driver will also be able to detect the
card. If the Plug & Play ROM-BIOS can not find the OME-PCI-1002, the software driver
will not function. Therefore the user must make sure that the power-on detection is
correct.
6.2 Driver Plug & Play Test
Step 1: Power-off the PC.
Step 2: Install OME-PCI-1002 without any extra external connector.
Step 3: Power-on PC and run DEMO7.EXE.
Step 4: The I/O base address of all OME-PCI-1002 cards installed in the system will be
displayed.
Step 5: Verify that the total number of boards is correct
Step 6: If more than one card, install a 20-pin flat cable on one of the OME-PCI-1002
45