Omega 1002 - Manual (Page 46)

46
cards.
Step 7: If a card’s D/O=D/I Æ this is the physical card number, remember this number.
Step 8: Repeat the previous two steps to find the physical card number of all boards.
6.3 D I/O Test
Step 1: Power-off the PC.
Step 2: Install one OME-PCI-1002 card with a 20-pin flat cable between CON1 & CON2.
Step 3: Power-on the PC then run DEMO2.EXE.
Step 4: The DO and DI are displayed as TEST OK or TEST ERROR.
6.4 A/D Test
• A/D Test for OME-PCI-1002 card
Step 1: Power-off the PC.
Step 2: Install one OME-PCI-1002 card.
Step 3: Power-on PC, run DEMO6.EXE
Step 4: Apply +10V to channel 0.
Step 5: Apply +0V to channel 1.
Step 6: Apply -10V to channel 2.
Step 7: Run DEMO6.EXE.
Step 8: Check channel 0 = fff or ffe?
Step 9: Check channel 1 = 800 or 801?
Step 10: Check channel 2 = 000 or 001?