Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 41)

Turning On & Basic Operations
En-41
Note
• You can cancel Audyssey MultEQ XT32 Room Correction and
Speaker Setup at any point in this procedure simply by
disconnecting the setup microphone.
• Do not connect or disconnect any speakers during
Audyssey MultEQ XT32 Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey MultEQ XT32 Room Correction and Speaker
Setup starts.
• Changes to the room after Audyssey MultEQ XT32 Room
Correction and Speaker Setup requires you run
Audyssey MultEQ XT32 Room Correction and Speaker Setup
again, as room EQ characteristics may have changed.
Error Messages
While Audyssey MultEQ XT32 Room Correction and
Speaker Setup is in progress, one of the error messages
below may appear.
The options are:
` Retry:
Try again.
` Cancel:
Cancel Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from that
of the first measurement. Check the speaker connection.
• Writing Error!
This message appears if saving fails. Try saving again. If
this message appears after 2 or 3 attempts, contact your
Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. “No”
means that no speaker was detected.
Tip
• See “Speaker Configuration” for appropriate settings
( ➔ page 13 ).
9 Use / to select an option, and then press ENTER.
The options are:
` Save:
Save the calculated settings and exit
Audyssey MultEQ
® XT32 Room Correction and
Speaker Setup.
` Cancel:
Cancel Audyssey MultEQ XT32 Room
Correction and Speaker Setup.
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using / .
Save
Cancel
MultEQ XT32: Auto Setup
AUDYSSEY
-- Review Speaker Configuration --
2ch
40Hz
40Hz
100Hz
None
100Hz
120Hz
2ch
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surround Back
Surround Back Ch
10 Use / to select a target, and use / to change
the setting.
After the results of Audyssey MultEQ XT32 have
been saved, the menu will display the “Audyssey”
(
➔ page 72 ), “Dynamic EQ” ( ➔ page 72 ),
“Dynamic Volume” ( ➔ page 73 ) settings.
Note
• When “Audyssey Quick Start” has been used for
measurement, “Audyssey” cannot be selected.
• These settings are applied to all input selectors.
11 Press ENTER.
12 Disconnect the speaker setup microphone.
Retry
Cancel
Ambient noise is too high.
AUDYSSEY
MultEQ XT32: Auto Setup
Error message