Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 72)

Advanced Operations
En-72
■ Equalizer *1
` Off
` Manual:
The manual setting in “Equalizer Settings”
(
➔ page 66 ) is applied.
■ Audyssey *1
` Off, Movie, Music
See “Audyssey” ( ➔ page 56 ).
■ Dynamic EQ *1*2
` Off, On
See “Dynamic EQ” ( ➔ page 56 ).
■ Dynamic Volume *1*2
` Off, Light, Medium, Heavy
See “Dynamic Volume” ( ➔ page 56 ).
■ Dolby Volume *1
` Off, On
See “Dolby Volume” ( ➔ page 56 ).
Note
• “Listening Mode” is only available when the input signal
matches the setting of “Sound Program”.
• You cannot select the “Subwoofer” setting if you set it to “No”
in “Speaker Configuration”.
• “Music Optimizer” is only available when “Stereo Source 1”,
“Stereo Source 2” or “Stereo Source 3” is selected.
• When “Audyssey Quick Start” has been used for measurement,
the “Audyssey”setting cannot be selected.
*1 This setting cannot be used when the “Listening Mode”
setting is set to “Pure Audio” or “Direct”.
*2 To enable this setting, you must first perform the Room
Correction and Speaker Setup.
Main Menu Source Setup
Items can be set individually for each input selector.
Audyssey ®
■ Audyssey
` Off
` Movie:
Select this setting for movie material.
The Audyssey indicator will light.
` Music:
Select this setting for music material.
The Audyssey indicator will light.
Note
• When “Audyssey Quick Start” has been used for measurement,
“Audyssey” cannot be selected.
• Audyssey equalizing does not work with DSD sources.
■ Dynamic EQ
` Off
` On:
Audyssey Dynamic EQ ® becomes active.
The Dynamic EQ indicator will light.
With Audyssey Dynamic EQ, you can enjoy great sound
even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating
sound quality as volume is decreased by taking into
account human perception and room acoustics. It does so
by selecting the correct frequency response and surround
volume levels moment-by-moment so that the content
sounds the way it was created at any volume level — not
just at reference level.
■ Reference Level
Audyssey Dynamic EQ Reference Level Offset
` 0dB:
This should be selected for movie contents.
` 5dB:
Select this setting for content that has a very wide
dynamic range, such as classical music.
` 10dB:
Select this setting for jazz or other music that has a
wider dynamic range. This setting should also be
selected for TV content as that is usually mixed at
10 dB below film reference.
` 15dB:
Select this setting for pop/rock music or other
program material that is mixed at very high listening
levels and has a compressed dynamic range.
Source Setup
Preparation
Press the input selector buttons to select an input source.
The tone for each speaker is set automatically by
Audyssey MultEQ
® XT32 Room Correction and
Speaker Setup. To enable the following settings, you
must first perform the Room Correction and Speaker
Setup (
➔ page 39 ).
• These technologies cannot be used when:
– a pair of headphones is connected, or
– either Pure Audio or Direct listening mode is selected.
1 2 3 4 5
“Setup”
To be continued