Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 5)

Safety Information and Introduction
En-5
Supplied Accessories
Make sure you have the following accessories:
* In catalogs and on packaging, the letter at the end of the product
name indicates the color. Specifications and operations are the
same regardless of color.
■ Installing the batteries
Note
• If the remote controller doesn’t work reliably, try replacing the
batteries.
• Don’t mix new and old batteries or different types of batteries.
• If you intend not to use the remote controller for a long time,
remove the batteries to prevent damage from leakage or
corrosion.
• Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
■ Aiming the remote controller
To use the remote controller, point it at the AV receiver’s
remote control sensor, as shown below.
Indoor FM antenna ( ➔ page 21 )
AM loop antenna ( ➔ page 21 )
(North American models) Two AM loop antennas and two
Indoor FM antennas are supplied.
Power cord ( ➔ page 22 )
Speaker cable labels ( ➔ page 14 )
Speaker setup microphone ( ➔ page 40 )
Remote controller (RC-840M) and two batteries (AA/R6)
Quick Start Guide
Batteries (AA/R6)
Thank you for purchasing an Onkyo AV Receiver.
Please read this manual thoroughly before making
connections and plugging in the unit.
Following the instructions in this manual will
enable you to obtain optimum performance and
listening enjoyment from your new AV Receiver.
Please retain this manual for future reference.
Remote control sensor
AV receiver
Approx. 16 ft. (5 m)