Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 90)

Controlling Other Components
En-90
Controlling Other
Components
You can use the AV receiver’s remote controller to control
your other AV components, including those made by other
manufacturers. This section explains how to enter the
remote control code for a component that you want to
control: DVD, TV, CD, etc.
See “Learning Commands” for learning commands
directly from another component’s remote controller
(
➔ page 95 ).
See “Using Normal Macros” for programming
ACTIVITIES to perform a sequence of remote control
actions (
➔ page 96 ).
The following REMOTE MODE buttons are
preprogrammed with remote control codes for controlling
the components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
indicated pages.
You can look up for an appropriate remote control code
from the on-screen menu.
Preprogrammed Remote Control
Codes
BD/DVD Onkyo Blu-ray Disc player ( ➔ page 93 )
TV/CD Onkyo CD player ( ➔ page 92 )
STB/DVR Apple TV
Looking up for Remote Control Codes
You need to connect your TV to the HDMI output
(
HDMI OUT MAIN) to make the following on-screen
setting.
1 Press RECEIVER followed by HOME.
2 Use / to select “Setup”, and then press ENTER.
3 Use / to select “Remote Controller Setup”, and
then press
ENTER.
4 Use / to select “Remote Mode Setup”, and then
press
ENTER.
5 Use / to select a remote mode, and then press
ENTER.
The menu of category selection appears.
6 Use / to select a category, and then press
ENTER.
The keyboard screen for brand name input appears.
7 Use / / / to select a character, and then press
ENTER.
Repeat this step for the first three characters of the
brand name.
When you have entered the 3rd character, select
“Search” and press ENTER.
A list of brand names is retrieved.
If the desired brand name is not found:
Use to select “Not Listed”, and then press
ENTER.
The keyboard screen for brand name input appears.
8 Use / to select a brand, and then press ENTER.
A remote control code with its instructions are
displayed. Follow the procedure.
9 If you can control the component, use / to select
“OK”, and then press
ENTER.
The on-screen menu returns to the “Remote Mode
Setup” front screen.
If you cannot control the component, use / to
select “Try Next Code” and press
ENTER.
The next code is displayed.