Onkyo Network A/V Receiver TX-NR1010 - Manual (Page 82)

Advanced Operations
En-82
■ Gateway
Enter the gateway address provided by your ISP.
■ DNS Server
Enter the DNS server address provided by your ISP.
■ Proxy URL
To use a Web proxy, enter its URL here.
■ Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
■ Network Standby
` On
` Off
This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (
➔ page 59 ).
Note
• When set to “On”, the power consumption slightly increases in
standby mode.
■ Update Notice
` Enable
` Disable
When this setting is enabled, you will be notified if a
firmware update via network is available.
Note
• Selecting “Never Remind me” on the notification window will
switch this setting to “Disable” ( ➔ page 23 ).
• For details on the update notification, see “If the “Firmware
Update Available” window appears.” ( ➔ page 23 ).
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See “Initial Setup” (
➔ page 24 ).
Main Menu Remote Controller Setup
Remote ID
■ Remote ID
` 1, 2, or 3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differentiate
the AV receiver from other components, you can change
its remote ID from “1”, to “2” or “3”.
Note
• If you do change the AV receiver’s remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won’t be able to control it with the remote controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(
➔ page 90 ).
Main Menu Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
■ Setup
` Locked
` Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
Remote Controller Setup
1 While holding down RECEIVER, press and hold
down Q SETUP until the RECEIVER lights (about
3 seconds).
2 Use the number buttons to enter ID 1, 2, or 3.
RECEIVER flashes twice.
1 2 3 4 5
“Setup”
Lock Setup
1 2 3 4 5
“Setup”