Onkyo TX-SA705 - Manual (Page 107)

107
Controlling Other Components—Continued
The AV receiver/AV amplifier’s remote controller can
learn the commands of other remote controllers. By
transmitting, for example, the Play command from your
CD player’s remote controller, the remote controller can
learn it, and then transmit the exact same command
when its Play [
] button is pressed in the CD remote
mode.
This is useful when you’ve entered the appropriate
remote control code (page 104) but some buttons don’t
work as expected.
Notes:
• The following buttons cannot learn new commands:
REMOTE MODE, MACRO [1], [2], [3], TV [ ],
TV [INPUT], TV CH [+]/[–], TV VOL [ ]/[ ],
Light.
• The remote controller can learn approximately 70 to
90 commands, although this will be less if commands
that use a lot of memory are learned.
• Remote controller buttons such as Play, Stop, Pause,
and so on are preprogrammed with commands for
controlling Onkyo CD players, cassette decks, and
DVD players. However, they can learn new com-
mands, and you can restore the preprogrammed com-
mands at any time by resetting the remote controller
(see page 105).
• To overwrite a previously learned command, repeat
this procedure.
• Only commands from infrared remote controllers can
be learned.
• When the remote controller’s batteries expire, all
learned commands will be lost and will have to be
learned all over again, so don’t discard your other
remote controllers.
Learning Commands
1 While holding down the REMOTE
MODE button for the mode in
which you want to use the com-
mand, press the [ON] button.
The Remote indicator lights up.
2 Press the button you want to
learn the new command.
1
1,4
Remote
indicator
3 Point the remote controllers at
each other, about 2 to 6 inches
(5–15 cm) apart, and then press
and hold the button whose com-
mand you want to learn until the
Remote indicator flashes.
If the command is learned successfully,
the Remote indicator flashes twice.
4 To learn more commands, repeat
steps 2 and 3.
Press any REMOTE MODE button
when you’ve finished.
PO WER
SLEEP
DIMMER
SUR MODE
VIDEO-1
VIDEO-2
TAPE
DVD
C D
C D
DVD
TU NER
TUNER
PHONO
INPUT SELECTOR
DISC
TAPE
VOLUME
EVE L
CH SEL
PRESET
MU TING
TEST TONE
MULTI-CH INPUT
GRO
UP
R
10
--/- --
11
12
REMOTE MODE
ZO NE 2
DVD
VCR
CD
RECEIVER
CABLE
DOCK
TAPE/AMP
AT CDR/MD
+
-
TV C H
T V VO L
SLEEP
INPUT SELECTOR
3
2
MACRO
1
+10
0
CLEA R
D.TU
N
1
2
3
4
5
6
7
8
9
INP UT
I
ON
STA N D BY
T V
TA PE
D V D
DC R/DV
R CBL/S
AT
AUX
MU LTI C
H
TUN ER
CD
PHONO
GA ME /TV
About 2 to 6
inches (5–15 cm)
RC-693M