Onkyo TX-SA705 - Manual (Page 98)

98
Advanced Setup—Continued
If several Onkyo components are used in the same room,
the remote controller’s control codes may overlap with
those of another component. To differentiate the remote
controller’s control codes, you can change its ID to
another number.
Note:
If you change the remote controller’s ID, be sure to set
the same ID on both the remote controller and AV
receiver/AV amplifier (see “Changing the AV Receiver/
AV Amplifier’s ID” on page 94). The default ID for both
is 1.
Changing the Remote Controller’s ID
1 Hold down the [RECEIVER] and the
TV [INPUT] buttons at the same time.
The Remote indicator flashes four times.
2 Use the number buttons to enter ID 1, 2,
or 3.
The Remote indicator flashes twice.
RECEIVER
INPUT
Number
buttons