Onkyo TX-SA705 - Manual (Page 77)

77
Advanced Setup—Continued
Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 54).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Note:
The Speaker Setup cannot be carried out while head-
phones are connected to the AV receiver/AV amplifier.
Speaker Settings
See “Speaker Settings” on page 46.
Speaker Configuration
With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.
The following crossover frequencies can be specified:
Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX),
90 Hz, 100 Hz, 120 Hz, 150 Hz, or 200 Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the
speaker. Refer to your speaker’s manuals to determine
the optimum crossover frequencies.
Please note that any THX main speakers should be set to
Small [80 Hz (THX)]. If you set up your speakers using
the Automatic Speaker Setup function, please make sure
manually that any THX speakers are set to Small with
80 Hz (THX) crossover.
Speaker Setup
This setting is set automatically by the Automatic
Speaker Setup function (see page 54).
2-11
1
2, 3
1, 12
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Config,” and then press [ENTER].
The Speaker Config menu appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “Subwoofer,”
and then use the Left and Right
[
]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
ENTER
ENTER
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
ENTER
ENTER
2–2. Speaker Config
Subwoofer Yes
Front 80Hz
Center 80Hz
Surround 80Hz
Surr Back
80Hz
Surr Back Ch 2ch
LPF of LFE 80Hz
Double Bass Off
ENTER
ENTER