Onkyo TX-SA705 - Manual (Page 95)

95
Advanced Setup—Continued
HDMI Audio Out
This preference determines whether audio received at
the HDMI IN is output by the HDMI OUT. You may
want to turn this preference on if your TV is connected
to the HDMI OUT and you want to listen to the audio
from a component that’s connected to an HDMI IN,
through your TV’s speakers. Normally, this should be set
to Off.
Off: HDMI audio is not output (default).
On: HDMI audio is output.
Notes:
• If On is selected and the signal can be output by the
TV, the AV receiver/AV amplifier will output no
sound through its speakers.
• When TV Control is enabled, this setting is set to
Auto.
• With some TVs and input signals, no sound may be
output even when this setting is set to On.
Lip Sync
The AV receiver/AV amplifier can be set to automati-
cally correct any delay between the video and the audio,
based on the data from the connected monitor.
Disable: HDMI lip sync disabled.
Enable: HDMI lip sync enabled.
Notes:
• This function works only if your HDMI-compatible
TV supports HDMI Lip Sync.
• You can check the amount of delay being applied by
the HDMI Lip Sync function on the A/V Sync screen
(see page 89).
xvYCC
If you set the xvYCC color function to Enable while a
source and monitor that both support the xvYCC color
standard are connected to HDMI, the color quality will
be improved.
Disable: xvYCC color disabled.
Enable: xvYCC color enabled.
Notes:
• If the color is unnatural when xvYCC color is set to
Enable, change the setting to Disable.
• Refer to the connected component’s instruction man-
ual for details.
HDMI Setup
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “5. HDMI,” and
then press [ENTER].
The HDMI menu appears.
4 Use the Up and Down [ ]/[ ]
buttons to select the settings and
use the Left and Right [
]/[ ]
buttons to select them.
The HDMI settings are explained
below.
ENTER
ENTER
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
ENTER
ENTER
7–5. HDMI
HDMI Audio Out Off
Lip Sync Disable
xvYCC Disable
Control Disable
Power Control - - -
TV Control - - -
ENTER
ENTER