Onkyo TX-SA705 - Manual (Page 96)

96
Advanced Setup—Continued
Control
This function allows CEC-standard-compatible equip-
ment connected to HDMI and
-compatible
equipment to be operated together with the AV receiver/
AV amplifier.
Disable: HDMI Control disabled.
Enable: HDMI Control enabled.
Notes:
• Set to Disable when a connected piece of equipment is
not compatible or it is unclear whether the equipment
is compatible or not.
• If movement is unnatural when set to Enable, change
the setting to Disable.
• Refer to the connected component’s instruction man-
ual for details.
■ Power Control
To link the electrical connection of CEC-standard-com-
patible equipment and
-compatible equipment
by means of HDMI, set to Enable. However, it may not
be possible to power link equipment, depending on the
settings and compatibility of the connected equipment.
Disable: Power Control disabled.
Enable: Power Control enabled.
Notes:
• The Power Control setting can be set only when the
above Control setting is set to Enable.
• HDMI power control only works with HDMI-compat-
ible components that support it.
• When set to Enable, power consumption will increase.
(North American models)
• The AV receiver/AV amplifier enters Ready mode
when set to Standby. (not North American models)
• Refer to the connected component’s instruction man-
ual for details.
■ TV Control
Set to Enable when you want to control the AV receiver/
AV amplifier from an -compatible TV that is
connected to HDMI.
Disable: TV Control disabled.
Enable: TV Control enabled.
Notes:
• Set to Disable when the TV is not compatible or when
it is unclear whether the TV is compatible or not.
• The TV Control setting can be set only when the
above Control and Power Control settings are both set
to Enable.
• Refer to the connected component’s instruction man-
ual for details.
Notes:
• After changing the settings of the Control, Power
Control, or TV Control, turn off the power to all
connected pieces of equipment and then turn on
again. Refer to the User’s Manuals for all con-
nected pieces of equipment.
• When HDMI Audio Out is set to “On” or the TV
Control is set to “Enable” and the audio is playing
through the TV speakers, if the volume is
adjusted on the AV receiver/AV amplifier, the
audio will begin to play through the speakers con-
nected to the AV receiver/AV amplifier. If you
want to turn off the audio from the AV receiver/
AV amplifier, repeat the set up operation, and the
set up for the TV, or turn down the volume to its
lowest level.