Onkyo DR-S2.0 - Manual (Page 21)

21
Press TEST TONE.
Each speaker emits the test tone (pink
noise) and the display shows the speaker
emitting the test tone in the following order:
Left
→
Center
(Front left ch.) (Center ch.)
↑ ↓
Subwfr Right
(Subwoofer) (Front right ch.)
↑ ↓
Surr L
←
Surr R
(Surround left ch.) (Surround right ch.)
Note
No test tone will be emitted from the speaker
which is not included in the speaker
configuration on page 19 even if it is actually
connected.
Press CH SEL repeatedly to select
the speaker, then press UP /
DOWN to adjust the volume level.
The volume level can be adjusted between
–12dB and +12dB.
2
Adjusting Each Speaker's Relative Volume Balance – Test Tone
Adjust each speaker’s relative volume balance so that the volumes of all speakers’ test
tones sound equal at the listening position.
INPUT SELECTOR
MODE
AU DIO
DVD
TV
TA/MD
LIS TEN ING MODE
A.C TR L
T – D STER EO
SU RR
TIT LE MEN U
SET UP
TV/V CR
RET URN
CH
TUN VOL ENTER
REPEAT MUTING
A – B
REC
DIMMER
OPEN/CLOSE
RANDOM SLOW
SUBTITLE – ON / OFF ANGLE ZOOM
MEMORY CLEAR AUDIO DISPLAY
-- / ---
SW MODE
LATE NIGHT DISTANCE
CH SEL
T– D SETUP UP/ DOWN
TEST TONE
SP A
SP B
1 2 3
4 5 6
7 8 9
+10 0 SEARCH
STNBY ON
SLE EP
1,3
2
2
When you have completed the
adjustment by repeating step 2,
press TEST TONE.
The test tone stops and the normal display
resumes.
Note
Even if you don’t press TEST TONE, the test
tone will stop after 10 cycles.
TEST TONE
2
1
Remote controller
only
UP/ DOWN
9
SEARCH
8
CH SEL
TEST TONE
2
3
dB