Onkyo DR-S2.0 - Manual (Page 28)

28
1
2
1
2
Listening to the Radio
3
There are two ways to select radio stations:
• Manual tuning
• Presetting radio stations then selecting the preset
channels
Presetting Radio Stations
You can preset up to 30 stations.
INPUT
FM MODE
STANDBY/ON
STANDBY
POWER
PHONES
OFF ON
TUNING/PRESET SURROUND STEREO T – D
DISPLAY
DVD / CD
PRESET MEMORY SUBWOOFER MODE SPEAKER SETUP SPEAKER A / B
ACOUSTIC CONTROL
INPUT
MASTER VOLUME
FM MODE 1 2,3
TUNING/PRESET
Unit
PRESET
MEMORY
TUNING/PRESET
4
Tuning in a weak frequency (only for FM stations)
When you tune in a stereo FM station, the FM ST indicator lights up
if the signal is sufficiently strong.
If the signal is weak, you may not be able to tune to the station.
In this case, press FM MODE. The FM MUTE indicator goes off.
Then select the station to which you want to listen.
(At this time, the station will be in mono and interstation noise will be
heard.)
3
TUNING/PRESET
Press INPUT / repeatedly to
select the band (FM or AM).
e.g. When FM is selected.
Note
You can also select the band with the remote
controller. See next page.
Press and hold TUNING/PRESET
q or w for about 1.5 seconds.
• When the band is FM
Auto tuning starts. The frequency
changes in 50 kHz steps.
When a broadcast is received, scanning
stops and the frequency flashes in the
display.
• When the band is AM
The frequency changes as follows:
– (USA and Canadian models)
In 10 kHz steps
– (Other models)
In 9 kHz steps
When you release the button, the frequency
stops changing and flashes in the display.
While the frequency is flashing (for
about 5 seconds), press TUNING/
PRESET
q / w to change the
frequency.
• The frequency changes each time you
press TUNING/PRESET q or w .
• You can change the frequency as long
as the frequency in the display is
flashing. Each press of either button
causes the frequency to flash for about
5 seconds.
Tuning Manually
Tune in the radio station you wish
to preset (see steps in the left
column of this page).
Press PRESET MEMORY.
The MEMORY indicator lights and the
preset number starts flashing in the
display.
While the MEMORY indicator is lit
(for about 8 seconds), press
TUNING/PRESET
q / w to
select the preset number.
Press PRESET MEMORY.
The radio station is registered to the
preset channel.
To register another preset station, repeat
steps 1 to 4.
FM MODE
STANDBY/ON
STANDBY
POWER
PHONES
OFF ON
TUNING/PRESET SURROUND STEREO T – D
DISPLAY
DVD / CD
PRESET MEMORY SUBWOOFER MODE SPEAKER SETUP SPEAKER A / B
ACOUSTIC CONTROL
INPUT
MASTER VOLUME
3 2,4
Unit only
PRESET
MEMORY
FM MODE
Unit Only
Unit only
FM
ch
FM ST
FM MUTE
ch
MEMORY
Appears when a broadcast is received.
ch
MEMORY