Onkyo HT-R960 - Manual (Page 104)

104
Troubleshooting —Continued
The AV receiver can upscale component video, S-Video,
and composite video sources for display on a TV that’s
connected to the HDMI OUT. However, if the picture
quality of the source is poor, upscaling may make the
picture worse or disappear altogether.
In this case, try setting the HDMI Output Resolution set-
ting to 480p or 720p (page 89). If that doesn’t improve
the picture quality, try the following:
1. If the video source is connected to a component
video input, connect your TV to the COMPO-
NENT VIDEO OUT.
If the video source is connected to an S-Video
input, connect your TV to an S-Video output.
If the video source is connected to a composite
video input, connect your TV to a composite video
output.
2. On the main menu, select “1. Input Assign,” and
then select “1. HDMI Input.” Select the relevant
input selector, and assign it to “-----” (page 46).
3. On the main menu, select “1. Input Assign,” and
then select “2. Component Video Input”
(page 47):
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to “IN1.”
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to “IN2.”
If the video source is connected to an S-Video or
composite video input, select the relevant input
selector, and assign it to “-----”.
The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely event
that this happens, unplug the power cord from the wall out-
let, wait at least 5 seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
this unit’s malfunction. Before you record important data,
make sure that the material will be recorded correctly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
Important Note Regarding Video
Playback