Onkyo HT-R960 - Manual (Page 87)

87
Advanced Setup —Continued
This section explains items on the Miscellaneous menu.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Volume Setup
■ Volume Display
With this setting, you can choose how the volume level
is displayed.
Absolute: Display range is Min, 1 through 99, Max.
Relative: Display range is –
∞
dB, –81 dB, –80 dB
through +18 dB (default).
The absolute value 82 is equivalent to the relative value
0 dB.
■
Muting Level
This setting determines how much the output is muted
when the Muting function is used (see page 51). It can be
set to –
∞
dB (fully muted) or from –50 dB to –10 dB in
10 dB steps (0 dB: default).
■ Maximum Volume
With this setting, you can limit the maximum volume.
When the Volume Display setting is set to Absolute, the
Maximum Volume range is Off, 99 to 50. When it’s set
to Relative, the range is Off, +17 dB to –32 dB. To dis-
able this setting, select Off.
■ Power On Volume
This setting determines what the volume will be each
time the AV receiver is turned on.
When the Volume Display preference is set to Absolute,
the range is Last, Min, 1 to Max. When it’s set to Rela-
tive, the range is Last, –
∞ dB, –81 dB to +18 dB.
To use the same volume level as when the AV receiver
was last turned off, select Last.
Note:
• The Power On Volume setting cannot be set higher
than the Maximum Volume setting.
■
Headphone Level
With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
headphone level can be set from –12 dB to +12 dB.
OSD Setup
■
Immediate Display
This setting determines whether operation details are
displayed onscreen immediately after an AV receiver
function is used.
On: Displayed (default).
Off: Not displayed.
Even if On is selected, operation details are not output if
the input source is connected to an HDMI IN and output
by the HDMI OUT.
For optimal video performance, THX recommends that
Immediate Display be turned off.
Miscellaneous Setup
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ]
buttons to select
“6. Miscellaneous,” and then
press [ENTER].
3 Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [ENTER].
4 Use the Up and Down [ ]/[ ]
buttons to select an item, and
use the Left and Right [
]/[ ]
buttons to change it.
The items are explained below.
5 When you’ve finished, press the
[SETUP] button.
Setup closes.