Onkyo HT-R960 - Manual (Page 91)

91
Advanced Setup —Continued
TV Control
Select Enable to control the AV receiver from an RIHD-
compatible TV that’s connected via HDMI.
Disable: TV Control disabled.
Enable: TV Control enabled.
Notes:
• Select Disable if your TV is incompatible or you’re
not sure about its compatibility.
• The TV Control setting can be set only when the above
Control and Power Control settings are both set to
Enable.
• When the Audio TV Out setting is set to On, or TV
Control is set to Enable and you’re listening through
your TV’s speakers (see page 35), if you turn up the
AV receiver’s volume control, the sound will be output
by the AV receiver’s speakers. To stop the AV
receiver’s speakers producing sound, change the set-
tings, change your TV’s settings, or turn down the AV
receiver’s volume.
With this setting, you can protect your settings by lock-
ing the setup menus.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Note:
• After changing the Control, Power Control, or TV
Control setting, be sure to turn all of your compo-
nents off and then back on again. Refer to the
instruction manuals for your other components.
Lock Setup
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ]
buttons to select “8. Lock Setup,”
and then press [ENTER].
3 Use the Left and Right [ ]/[ ]
buttons to select:
Locked: Setup menus locked.
Unlocked: Setup menus unlocked.
When Locked is selected, only this
Lock Setup item can be accessed.
4 Press the [SETUP] button.
Setup closes.