Orion LBI-38888K - Manual (Page 47)

47
METHOD 2: Press p to enter the overdial select/entry mode and
follow the selection mode rules to call up a stored number
from the phone list or to directly enter the overdial digits.
Press PTT to send the overdial sequence once. If the
number needs to be transmitted again it must be selected or
entered again (this prevents unwanted numbers from being
sent the next time the PTT button is pressed during the
call).
This overdial select/entry mode remains active until the call
is dropped, cleared, or m is pressed. The overdial
select/entry mode can be re-entered if the call is still active
by pressing p .
Programmable Entries
Individual call ID numbers, telephone numbers and other number sequences
for overdialing are stored in the special call lists when programming the
radio. The first ten entry locations of these lists can be changed by the radio
operator. The keypad is used when adding, changing and storing numbers in
these entry locations.
Use the following procedure to store a number in one of the first ten entries
of a special call list:
1. Press i or p to enter the individual call list or the phone call list.
The selection mode rules apply.
2. Scroll through the list using the RAMP control
, or . until one of
the first ten entries is reached. NO ENTRY is displayed if the location
is empty.
3. Enter the desired number. If necessary, a pause can be entered by
pressing and holding 0-9, (*), or (#) until an underscore appears in the
display. The individual call list entries will accept up to 5 digits. The
phone call list entries accept a combination of up to 31 digits and
pauses.
4. Press and hold m until the display changes indicating that the number
has been stored.
5. Repeat the steps above if the number stored in an entry location needs to
be changed.