Oki ML520 User Manual
Page 116
Page: 84
Service Guide ML520/521
Chapter 3 Maintenance & Disassembly
3.2.15 Guide Rail and Adjust Cam
1. Perform these procedures:
3.2.01
, 3.2.02
, 3.2.04
, 3.2.10
, 3.2.11
, and 3.2.14
.
2. Rotate the adjust cam (1) in the direction of arrow A as far as possible.
3. Pull the cam out and remove it.
4. Carefully press the claw (2
location only) in the base frame down to release the guide rail (3). Do not
press too hard or the claw will break.
5. Use a straight slot screwdriver to slide the guide rail in direction of arrow A.
6. Lift the guide at position B and work the other end of the guide free to remove the guide rail.
7. Remove the ground clip (4)
NOTE:
Installation After installing the guide rail, check the printhead gap adjustment. Refer to Section
3.3 of this Service Handbook.
P/N 51009701 Guide: Rail Ground Clip RSPL Both B.2.04