Oricom Secure 500 - Manual (Page 13)

11 BASIC OPERATION
Once you have set up your Baby Monitor, you will be able
to hear the sounds in your baby's room through the Parent
Unit. And also see the green and red sensor lights around
the top of the Parent Unit rise and fall with the sound levels.
• If the connection between the Parent and Baby
Units is broken at any time the green Link light on
the Parent Unit will flash slowly, the parent unit will
beep to alter you that the link has been lost and the
green and red sensor lights will cease to react to any
sounds. Move closer to the baby unit or follow the
directions in chapter "Troubleshooting" to re-establish
the link.
Power On/Off
Baby Unit
• Press [ ] key to switch on the unit.
• The Green Link light comes on to show that the unit
is within range of the Parent unit.
• To switch Off, press [ ] key until the display goes
blank and the link light goes off.
Parent Unit
• Press and hold [ ] key. The Link LED on the far left
will illuminate.
• Keep pressing the button until the 3 LEDs to the
far right illuminate as well. The Parent unit is now
switched on and will search for and link itself to the
Baby unit.
• Green LINK Light is lit while unit searches for the
baby unit.
• To switch Off, press [ ] key until the display goes
blank and the link light goes off.
Changing Baby unit from battery to
mains power
• To conserve battery power on the Baby unit or when
the batteries are low or fl at, plug the Baby unit into the
mains. If currently running on batteries and switched
on, changing from battery to mains power will be instant
and will not affect any of the settings.
• You can use the Parent unit to monitor baby while it is
charging.
Monitoring
• Position the baby unit accordingly. It should be placed
at least 1 metre away from the baby.
• Take the parent unit to monitor.