Oricom Secure 500 - Manual (Page 19)

17
Parent Unit
When the batteries on the Parent Unit reach a low level, the
display will show Low Battery. The low battery alert tone will
be emitted from the speaker every 60 seconds. Once the
low battery level is reached, the parent unit should still be
able to operate for approximately 1 hour and 30 minutes.
The low battery alert message and alert tone will be turned
off when fully charged batteries have been replaced.
Charging the Battery
Place the parent unit on its charge cradle to charge the
battery. When charging, the red LED on the charger will
light steadily. The bars in the battery icon on the Parent
Unit will scroll. When the battery is full, the battery icon
shows three bars and stops scrolling.
Note:
The Parent Unit must never be operated on the charging
cradle without batteries.
The parent unit can be used on or off the charger pod.
When on the charger pod, the batteries will be recharged
at the same time. However, the time it takes to charge the
batteries to full will be longer when the unit is charged and
used at the same time.
Rechargeable batteries in the Parent unit give up to 12
hours continuous usage. Please note however, that new
batteries do not reach full capacity until they have been in
normal use for several days.
Running rechargeable batteries right down at least once a
week will help them last as long as possible. The charge
capacity of rechargeable batteries will reduce with time as
they age, so reducing the performance time of the parent
unit. Eventually they will need to be replaced.
Restore to Default Setting
You can return the baby and parent units to factory default
settings.
1 Press
[ ] to switch the unit off.
2 Press [ ] again to switch the unit back on.
3 While the unit is switching on, press and hold the [ ] key
on the parent unit or the [–] key on the baby unit until
you hear a beep. RESET is showed on the display. The
unit will restore all the original factory settings.
Note:
If [ ] or [–] is not pressed within 4 seconds, the unit
returns to idle mode.
If you want to restore the factory default settings on the
baby monitor, you will need to restore factory default
setting on the Baby Unit or on the Parent Unit individually.
BASIC OPERATION