Oricom TP170WP - Manual (Page 5)

5
3 Installation
3.1 Installing batteries (supplied) in the phone
Warnings
You must install 4 AA Alkaline batteries in the phone base. The battery
back up system will then be able to power the unit for up to 12 hours if
there is a mains power failure.
If your mains power has been turned off for an extended period or the
power supply to the phone has been unplugged from mains power you
should replace the batteries with 4 new high quality AA Alkaline batteries.
Before opening the battery compartment, make sure the telephone is
disconnected from the telephone line and the mains power supply.
1. Use a flat-blade screwdriver or tip of a pen to lift and remove the battery
compartment door.
2. Insert four AA batteries into the compartment as indicated by the polarity
symbols.
3. Snap the battery compartment door back into place.
When this symbol appears on the display or the display dims, replace the
batteries. Always use 4 new high quality Alkaline AA batteries.
3.2 Connecting the mains power supply
Insert the plug of the power supply into the round socket at the back of the
telephone and plug the power supply into a working mains power point. The
power adaptor must be connected to mains power and the wall switch be
turned on at all times.
CAUTION
Use only the mains adapter supplied with this product. Incorrect adaptor
polarity or voltage can seriously damage the unit.
Adaptor for base:-
Input: 240 VAC 50 Hz
Output: 9VDC 200 mA
3.3 Connecting the telephone
1. Plug one end of the telephone cable supplied into the TEL. LINE jack at
the back of the telephone base.
2. Plug the other end of the telephone cable into the wall outlet.
3. Plug one end of the curly cord into the socket on the handset.
4. Plug the other end of the curly cord into the left side of the telephone.