Oricom TP170WP - Manual (Page 8)

8
4.5 Receiver Volume Control
The receiver volume control enables you to adjust the receiver volume on
the handset. Rotate the button on the base to select a comfortable listening
level (1-9), the red LED will turn on.
WARNING
Setting the receiver volume to maximum may, under some situations
cause ear damage. We suggest returning the volume control to the “0”
(OFF) position after each call.
4.6 Hearing Aid Compatibility
This unit is compatible with most inductively coupled hearing aids on the
market. However due to the wide range of hearing aids available we cannot
guarantee that the TP170WP will function error free with every model.
4.7 Receiver Tone Volume Control
You can use the TONE slide switch to adjust high frequency sounds. Words
are clearer and easier to understand. Note: The tone adjustment function will
not work if the receiver volume is set to the minimum level.
4.8 Selecting the ringer melody
1. Press and release the MENU button until RINGER MELODY is shown.
2. Press the OK button, the display shows RINGER MELODY 1.
3. Select the desired RINGER MELODY 1, 2 or 3 using or and confirm
with OK button.
4. Press
CID
to exit the set-up mode.
4.9 Ringer Volume Control
The ringer sound level can be adjusted by sliding the RINGER switch. Select
high (HI), mid (MID) or low (LO) level.
The bright Red light (LED) on the base will flash with all incoming calls.
5. REMOTE PENDANT
The telephone comes with one waterproof emergency pendant which is already
paired with the unit.
Please contact your local re-seller to purchase additional emergency pendants.
These can be used by another person in the house or to have a spare pendant
in more than one room (like bathroom and bedroom).
The following information is for pairing additional pendants only or if you
accidently have deleted the pendant from the “pairing menu”