Omron Healthcare VARISPEEDF7 - Manual (Page 15)

EN-14
Keypad Operation
‹
Digital Operator Display (optional)
The key names and functions of the Digital Operator are described below
„
Digital Operator Keys
Key Name Function
LOCAL/REMOTE Key
Switches between operation via the Digital Operator (LOCAL) and
the settings in b1-01 and b1-02 (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
MENU Key Selects the modes.
ESC Key Returns to the status before the DATA/ENTER Key was pressed.
JOG Key
Enables jog operation when the Inverter is being operated from the
Digital Operator.
FWD/REV Key
Selects the rotation direction of the motor when the Inverter is being
operated from the Digital Operator.
Shift/RESET Key
Sets the active digit when programming user parameters.
Also acts as the Reset key when a fault has occurred.
Increment Key
Selects user parameter numbers and increments parameter set-
tings.
Used to move to the next item or data.
Decrement Key
Selects user parameter numbers and decrements parameter set-
tings.
Used to move to the previous item or data.
DATA/ENTER Key Enters menus and parameters and validates parameter settings.
RUN Key
Starts operation when the Inverter is being controlled by the Digital
Operator (LOCAL Mode).
STOP Key
Stops Inverter operation (LOCAL and REMOTE Mode).
This key can be enabled or disabled when operating from a source
different tan the operator by setting parameter o2-02.
Drive Mode Indicators
FWD: Lights up when a forward run command is
input.
REV: Lights up when a reverse run command is
input.
SEQ: Lights up when any other run command
source than the Digital Operator is selected.
REF: Lights up when any other frequency reference
source than the Digital Operator is selected.
ALARM: Lights up when an error or alarm has
occurred.
Data Display
Displays monitor data, parameter numbers, and set-
tings.
Mode Display (displayed at the upper left of the data display
DRIVE: Lights up in Drive Mode.
QUICK: Lights up in Quick Programming Mode.
ADV:
Lights up in Advanced Programming Mode.
VERIFY:Lights up in Verify Mode.
A. TUNE:Lights up in Autotuning Mode.
Keys
Execute operations such as setting user parameters,
monitoring, jogging, and autotuning.