Omega FC-21 - Manual (Page 33)

29
FC-21 Flow Computer
Sub-menus Display Notes
6.4.12
SET FLUID
PROPERTIES SET FLUID PROPERTIES
REF. DENSITY
###### lbs/g
REF. TEMPERATURE
###### F
EXPAN. FACTOR [xe-6]
########
CALIBRATION DENSITY
########
VISCOSITY COEF. A
0.000
VISCOSITY COEF. B
0.000
BASE DENSITY H2O@4C
###### lbs/g
Advance To
SETUP PULSE OUTPUT
ENTER
ENTER
ENTER
ENTER
Press ENTER at this prompt to Set Fluid
Properties.
Enter the Reference Density. This is used in
the calculation of density when you have a
temp transmitter and used for corrected flow
calculation if you have a density transmitter.
Enter the Reference Temperature.
Enter the proper Expansion Factor.
(If Temp Compensated for Mass or Corrected
Volume) See Section 7.4, Calculating the
Expansion Factor.
Enter the Calibration Density. This is used in
calculation of flow for analog inputs using SQRT.
Enter the Viscosity A Coefficient. See section
7.5, Computation of Viscosity Coef. A and B.
Enter the Viscosity B Coefficient. See section
7.5, Computation of Viscosity Coef. A and B.
Enter the Base Density H2O@4C. This is
used in the centistoke calculation for UVC.
6.4.13
SETUP
PULSE OUTPUT Press ENTER at this prompt to setup the
Pulse Output.
Select the desired Pulse Output Usage.
Select the desired Pulse Width for the Pulse
Output.
Enter the desired Pulse Value for the Pulse
Output (Units per Pulse).
ENTER
ENTER
ENTER
ENTER
SETUP PULSE OUTPUT
PULSE OUTPUT USAGE
Off Vol CVol/Mass
PULSE WIDTH
10mS 100mS
PULSE VALUE
####### gal/P
Advance To
SETUP ANALOG OUTPUT
ENTER
ENTER
ENTER
ENTER