Onkyo TX-NR5007 - Manual (Page 52)

52
First Time Setup
—Continued
If you connect your TV to the HDMI output, set the
“Monitor Out” setting so that the onscreen setup menus
are displayed and composite video, S-Video, and
component video sources are upconverted and output.
If you connect your TV to the COMPONENT VIDEO
MONITOR OUT, set the “Monitor Out” setting so that
the onscreen setup menus are displayed and composite
video and S-Video sources are upconverted and output.
You can specify the output resolution for the HDMI
outputs and COMPONENT VIDEO MONITOR OUT
and have the AV receiver upconvert the picture
resolution as necessary to match the resolution
supported by your TV.
Monitor Out Setup
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select “1. Input/Output
Assign”, and then press
[ENTER].
The “Input/Output Assign” menu
appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “1. Monitor Out”,
and then press [ENTER].
The “Monitor Out” menu appears.
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
Monitor Out
Resolution
Brightness
Contrast
Hue
Saturation HDMI Main
Through
0
0
0
0
1–1. Monitor Out
4 Use the Up and Down [ ]/[ ] but-
tons to select “Monitor Out”, and
use the Left and Right [
]/[ ]
buttons to select:
Analog:
Select this if your TV is connected
to the COMPONENT VIDEO
MONITOR OUT, S MONITOR
OUT, or V MONITOR OUT.
HDMI Main:
Select this if your TV is connected
to the HDMI OUT MAIN.
HDMI Sub:
Select this if your TV is connected
to the HDMI OUT SUB.
Both:
Select this if your TVs are con-
nected to the HDMI OUT MAIN
and HDMI OUT SUB. Video sig-
nals are output from both HDMI
outputs at the resolution supported
by both TVs.
Both (Main):
Select this if your TVs are con-
nected to the HDMI OUT MAIN
and HDMI OUT SUB. Video sig-
nals are output from both HDMI
outputs but HDMI OUT MAIN will
become a priority; depending on the
resolution, video signals may not be
output from HDMI OUT SUB.
Both (Sub):
Select this if your TVs are con-
nected to the HDMI OUT MAIN
and HDMI OUT SUB. Video sig-
nals are output from both HDMI
outputs but HDMI OUT SUB will
become a priority; depending on the
resolution, video signals may not be
output from HDMI OUT MAIN.
Notes:
• If not connected to the same output
you have selected in the“Monitor
Out” setting, the “Monitor Out”
setting will be automatically
switched to “Analog”.
• When you select other than
“Analog”, the onscreen setup menus
are output by only the HDMI
outputs. If you’re not using the
HDMI output and select settings
by mistake and the menus
disappear, press the [MONITOR
OUT] button to select “Analog”.
• For Deep Color output, if the
“Monitor Out” setting is set to “Both
(Main)” or “Both (Sub)”, the number
of bit may be limited due to the
capability of your TV connected to a
priority output.