Onkyo TX-NR5007 - Manual (Page 95)

95
Advanced Setup
—Continued
Some of the settings in this section are set automatically by Audyssey MultEQ
®
XT Room Correction and Speaker
Setup (see page 61). For Speakers B, you need to change the settings manually.
Here you can check the settings made by Audyssey MultEQ
® XT Room Correction and Speaker Setup, or set them
manually, which is useful if you change one of the connected speakers after using Audyssey MultEQ
®
XT Room Cor-
rection and Speaker Setup.
Note:
The Speaker Setup cannot be carried out while headphones are connected to the AV receiver.
Speaker Setup
1 Press the [RECEIVER] button, and then
use the remote controller’s [SP LAYOUT]
button to select Speakers A or
Speakers B.
Note:
Speakers B cannot be selected if “Speakers
Type(FrontB)” is set to “Not Use”.
2 Press the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make sure the
appropriate external input is selected on your TV.
3 Use the Up and Down [ ]/[ ] buttons to
select “2. Speaker Setup”, and then press
[ENTER].
4 Use the Up and Down [ ]/[ ] buttons to
select the submenu, and then press
[ENTER].
5 Use the Up and Down [ ]/[ ] buttons to
select setting, and then use the Left and
Right [
]/[ ] buttons to set them.
6 When you’ve finished, press the [SETUP]
button.
The setup menu closes.
Speaker Settings
See “Speaker Settings” on page 57.
Speaker Configuration
With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. You
can set the crossover frequencies, distances, and levels of the front Speakers A and front Speakers B independently.
The other speakers (i.e., subwoofer, center, surround, and surround back) use the same crossover frequencies, dis-
tances, and levels for Speakers A and Speakers B. The following crossover frequencies can be specified: “Full Band”,
“40Hz”, “50Hz”, “60Hz”, “70Hz”, “80Hz(THX)”, “90Hz”, “100Hz”, “120Hz”, “150Hz”, or “200Hz”. Specify “Full
Band” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good sized
woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by
the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequen-
cies.
If you set up your speakers using Audyssey MultEQ
® XT Room Correction and Speaker Setup, please make sure
manually that any THX speakers are set to “80Hz(THX)” crossover.
Subwoofer 1ch: Audio signal is outputted from SW1 jack only.
2ch: Audio signal is outputted from SW1 and SW2 jacks (default).
No: Select if no subwoofer is connected.
Front
*1 Full Band, 40Hz, 50Hz, 60Hz, 70Hz, 80Hz(THX) (default), 90Hz, 100Hz, 120Hz,
150Hz, 200Hz
Center
*2
Surround
*2
Front Wide
*2*3*5*7
Front High
*2*3*7*10
Surr Back
*3*4*6
Full Band, 40Hz, 50Hz, 60Hz, 70Hz, 80Hz(THX), 90Hz, 100Hz, 120Hz, 150Hz,
200Hz
None: Select if no speaker is connected.