Onkyo TX-NR5007 - Manual (Page 70)

70
Basic Operations
—Continued
Front High or Front Wide Speakers
When “Speakers Type(FrontB)” setting is set to “Not
Use”, you can select the priority of the use of Front High
or Front Wide speakers.
Notes:
• Front High or Front Wide speakers cannot be selected
in either of the following cases:
1. “Speakers Type(FrontB)” is set to “Bi-Amp”,
“BTL”, or “Normal” (page 57).
2. Powered Zone 2 is being used (page 134).
• When the listening mode that doesn’t support Front
High or Front Wide speakers is used, the setting can-
not be selected.
• If you use surround back speakers, the speaker selec-
tion will be based on the combination of surround
back and front high speakers, or surround back and
front wide speakers.
Speakers A or Speakers B Configuration
When “Speakers Type(FrontB)” setting is set to other
than “Not Use”, you can choose which of the speakers
you want to use with the Speakers A or Speakers B con-
figuration. Speakers A or B can be switched regardless
of listening modes.
Notes:
• When you use Speakers B configuration, you cannot
use front high and front wide speakers.
• When you use Speakers B configuration, listening
modes that require front high or front wide speakers
such as Dolby Pro Logic IIz Height or Audyssey
Dynamic Surround Expansion™ are unavailable.
• While you are using Speakers B, you cannot use
Audyssey MultEQ
®
XT Room Correction and
Speaker Setup (Audyssey Dynamic EQ™ and
Audyssey Dynamic Volume™).
You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the Headphone indicator, speaker/channel indi-
cator FL and FR light up. (The Powered Zone 2/3
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, Pure Audio or DTS Surround Sensa-
tion.
• Listening mode automatically changes into DTS sur-
round sensation when you connect a pair of head-
phones while DTS surround sensation mode is
currently selected.
• The following listening modes can be used with head-
phones (the listening modes available also depend on
the currently selected input source): Stereo, Direct,
Pure Audio, Mono and DTS Surround Sensation.
Selecting Speaker Layout
Remote
controller
Press the [RECEIVER] button,
and then press the [SP LAYOUT]
button repeatedly.
Using Headphones