Toshiba 6F3B0253 - Manual (Page 25)

6F3B0253
Basic Hardware and Function
23
1. System Configuration
I/O status LEDs:
Indicates the ON/OFF status of each I/O signal. (color: red)
SW54 setting
value I/O intending for an indication Note
0 (default) Basic unit (L: X000-007, H: Y020-027)
1 I/O module slot 0
2 I/O module slot 1
3 I/O module slot 2
4 I/O module slot 3
5 I/O module slot 4
6 I/O module slot 5
7 I/O module slot 6
8 I/O module slot 7
9 TOSLINE-F10 (FR112M), Low 1 word
10 TOSLINE-F10 (FR112M), High 1 word
It indicates these at the
time of only RUN
mode.
Others Basic unit (L: X000-007, H: Y020-027)
Operation status LEDs:
Indicates the operation status of the T1-16S.
FLT
RUN
PWR
Lit Internal 5 Vdc power is normal. PWR
(Power) (green) Not lit Internal 5 Vdc power is not normal.
Lit RUN mode (in operation)
Blinking HOLD mode
RUN (green)
Not lit HALT mode or ERROR mode
Lit ERROR mode
Blinking Hardware error (programmer cannot be connected)
FLT
(Fault) (red)
Not lit Normal
Mode control switch:
Controls the operation modes of the T1-16S.
H (HALT) When the switch is turned to H (HALT) side, the T1-16S stops
program execution (HALT mode). In this position, RUN/HALT
command from the programmer is disabled.
R (RUN) When the switch is turned to R (RUN) side, the T1-16S starts
program execution. This is the position during normal operation.
In this position, RUN/HALT command from the programmer is also
available.