Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH - Manual (Page 85)

84
ICC
Figure 86: XIO Instruction Selection
5) Configure the MSG instruction.
a) Set the “Read/Write” field to “Read”, “Target Device” field to “PLC5”,
“Local/Remote” field to “Local”, and “Control Block” to “N20:0”.
b) Upon hitting the <ENTER> key while in the “Control Block” entry box,
the MSG Properties dialog box should appear (or it can be opened by
clicking on the “Setup Screen” button at the bottom of the MSG
instruction). Refer to Figure 87.
Figure 87: MSG Configuration, "General" Tab