Tiger NEW HOLLAND T6000 - Manual (Page 37)

ASSEMBLY
Assembly Section 2-5
MIRROR MOUNT
1. Remove the existing mirror bracket and mirror from the cab.
2 Remove the mirror and knob from existing bracket.
3. Install the supplied bracket (using supplied hardware) on the cab as
shown below.
4. Install the mirror with the knob on the supplied bracket as shown below.
Refer to the Parts section for details.
T
A. Mirror/Light Mount Bracket
B. Existing Hardware
C. Distance the muffler screen is cut back to
fit the exhaust collar
- Half distance from the top bolt hole to
to the top of the screen.
(ASM-NH-0053)
LIGHT MOUNT
1. Remove light and light bracket from hand rail.
2. Tape light back against the hand rail next to the cab.
3. At the base of the hand rail, cut through the rail 2” from the cab.
4. To disconnect the wiring for the light, cut the hand rail through the hole where the
wires extend.
5. Disconnect green connector, or wires inside light assembly, and pull wire through the
hand rail.
6. Cut the hand rail 2” from the frame.
7. Place a small amount of adhesive on outer edge of the lower hand rail stub. Slide
rubber cap on the stub.
8. Take second rubber cap and cut a small “X” at the end. Feed the light wire through the
cap, the hand rail. Re-attach green connector or wires inside light assembly.
9. Place small amount of adhesive on outer edge of upper hand rail stub. Slide rubber
cap on the stub.
10. Mount light to mirror bracket.
(ASM-NH-0054)