Tiger NEW HOLLAND T6000 - Manual (Page 38)

ASSEMBLY
Assembly Section 2-6
4 CYLINDER EXHAUST MOUNT
NOTE: This should be done after mounting the main frame.
1.
Cut the tractor hood as shown in Pic. #1 to accomodate modified exhaust turbo tube.
2. Remove the muffler from existing turbo tube.
3. Remove existing turbo tube from tractor turbo.
4. Install the exhust mounting bracket and supporting brace.
5. Cut the existing tube at turbo end 4-3/8” from hole center as shown in Pics. #2 and
#3. Discard remaining portion of existing tube.
6. Install the turbo end of existing tube to the tractor turbo.
7. connect the supplied tube to the turbo end of existing tube using the sealing clamp as
shown in Pic. #4. Do not tighten the hardware.
8. Install the exhaust clamp to the exhaust mounting bracket with the supplied
hardware. Refer to the Parts Section for details.
9. Tighten the turbo existing hardware first and then the rest of the hardware.
10. Cut the muffler sweep off at the top and replace with a raincap, if necessary for
shipping, as shown in Pic. #5. Install muffler to the turbo tube with the existing
hardware.
(ASM-NH-0055)
Picture
#1
Picture #2 Picture #3