Tiger NEW HOLLAND T6000 - Manual (Page 63)

ASSEMBLY
Assembly Section 2-31
AXLE BRACE MOUNTING
The axle braces are to be mounted under the rear axle of the tractor with spacers. The
other end of the axle braces mount to the outside of the lower rear corners of the main frame.
After attaching the boom rest, it should fit tightly and level under the tractor. Attach the axle
braces to the main frame with hardware shown in the Parts Section and tighten. Attach the axle
braces to the rear axle using the axle spacers and mounting hardware shown in the Parts
Section, but DO NOT tighten.
BOOM REST MOUNTING
Carefully raise the boom rest and align the holes with those of the axle brace. Now install all
attaching hardware as shown in the Parts Section loosely, to allow for the alignment with the left
and right axle brace. Tighten / torque all hardware on the brace and the boom rest. Finally, add
the rest strips to the boom rest as shown in the Parts Section.
(ASM-JD-0095)
BOOM MOUNTING BRACKET
Using a floor jack and/or a hoist, raise the boom mounting bracket up to level and slide the
bracket into position onto the main frame as shown in the Parts Section.
Install the pin through main frame and bracket. Secure with capscrew and nylock nut through
the boss on the main frame.
Secure mounting bracket to the main frame with the capscrews, flatwashers, cut flatwashers
and nylock nuts provided. Secure through the two slotted holes on the bracket and main frame.
(ASM-C-0084)