Texas Memory Systems 325 - Manual (Page 92)

the administrator resets this controller back to “Primary (Active)” state
result in errors because the drives appear to have been removed. TMS
does not recommended configuring an active secondary controller as
primary unless no transmissions are taking place.
Via Web Interface
To change the failover state via the web interface:
• Click on the “Fibre Channel Controller” graphic.
• Click on the “Controller Setup” tab.
• Select from the “Select failover mode” settings.
• Click the “Save” button.
Figure 7-4: Failover Setup via Web Interface
RamSan-300/320/325 User’s Manual - 88 -