Tektronix AD007 - Manual (Page 40)

Getting Started
26 AD007 User Manual
Accessing the Web Page Interface
The AD007 adapter has a built-in web server with online forms that
allow you to test the network connection, configure a printer, and
make various network or GPIB settings. Use the following procedure
to access the web pages:
1. Start the web browser on your computer.
2. Open the location of the AD007 adapter assigned by your
network administrator:
http://AD007 host name or IP address/
3. Use the settings on your browser to save or bookmark this
location.
If you successfully access the Home web page, the network portion
of the installation is now complete. For more information about the
web page interface, see Operating Basics on page 33.
If you only access a diagnostic web page, there is a problem with the
firmware in the adapter. See the AD007 section in the Tektronix
Software Solutions Installation manual (Tektronix part number
071--1140--01) for instructions on updating the AD007 firmware.
NOTE. If you cannot access any web page of the adapter, contact
your network administrator or network technician.
Do not change any parameters on the Network Setup without
contacting your network administrator. A password protection utility
is available on the Home page to protect these settings. See page 35.
Password Protection
The settings on the web pages are password protected. If you try to
make changes to the settings, the browser will prompt you for a user
name and password. By default, the user name is ignored and the
password is ad007 (lowercase a, lowercase d, zero, zero, 7). To set a
new password, see page 35. To reset the password to the default
setting, see Resetting the Adapter on page 48.